These values position the dormer roof above the main roof.
Roof to wall line revit.
Use the pick walls tool to create 3 of the roof boundary edges.
Create the roof of the dormer using the walls we just placed.
In the image below you can see the lines that i ve changed on the left.
Select the wall and use the attach top base button to attach it to the underside of only the 5 1 2 roof.
Sketch mode is used to allow you to define the boundary of your roof.
Once again select the wall first 1.
On the properties palette set the base constraint to roof line and enter an offset of 2000 and an overhang of 100.
My problem ist that when i make a section the outer wall goes into the roof.
The first one is to right click the blue boundary point of the wall and click on disallow join.
Revit then makes the wall meet the underside of the roof correctly.
Adjusts the horizontal offset of the line from its associated wall.
After the sketch is complete finish the roof.
In the dialog click yes to attach the dormer walls to the roof.
The next step is to drag the boundary point to the limit of the wall.
I hope my problem is clear when you look at the screenshot.
Hello i m relatively new to revit and this forum and i hope i m doing this right.
Roof by footprint can be used for both flat and sloped pitched roofs.
Use the line segment tool to create the last edge.
Available only when picking walls.
I just need to go around the rest of the perimeter and apply the overhead line style.
Thanks for the help 39377.
Then from the modify tab on your ribbon use the join geometry command and select the 7 1 2 roof and the wall.
For footprint roofs specifies a roof line to be a slope defining line.
Select the roof tool.
It will join in the wrong order and you will need to use the drop down menu next to join to switch the join order.
But i want it to end at the roof where i painted the red line.
With this line style selected all i need to do is click on each line that i want to apply this style to which is all the lines that make up the perimeter of the roof boundary.
This height is relative to the base level of the roof.
The defines roof slope parameter allows you to toggle which parts of your roof are inclined.
If you want to bring back the wall join select the wall and click on the small icon like in the image below.
