Roof Trusses Reiforcement

Truss design drawings shall be provided to the building official and approved prior to installation r802 10 1.

Roof trusses reiforcement.

Roof trusses are a common means of support and load bearing. Trusses form the roof line on buildings and provide support for the lumber that holds shingles or other form of roof cover. Reinforce your roof a properly constructed roof in areas subject to high winds has trusses attached to walls with hurricane tiedowns properly nailed sheathing and heavy duty shingles. The trusses needed to be lifted to their original height and cut flush with the inside face of the cmu wall with the rotted sections removed.

Truss design drawings shall include the following information. Consult your local code officials for details. Some bracing provides a way to put up the trusses evenly while holding them and other bracing supports them after they are put up. However if you want to better utilize the space in your loft you may consider changing roof trusses and going for stick framing or rafters instead.

The first step to reinforcing the roof is to add an x to the frame. Remember any alterations to a roof should be undertaken only with an engineer. Continue reading below our video of the day. Truss design drawings shall be provided with the shipment of the trusses delivered to the job site r801 10 1.

O slope or depth span and spacing o location of all joints. To reinforce the ends of the trusses 3 4 inch plywood gussets were to be attached to both sides of each truss with 10d nails 3 inches on center on all chords. These are usually accomplished during a complete re roofing. If you don t have an a frame roof you can run parallel boards between the studs to further offer support and to strengthen the frame.