Roof Water Diverter Installation

Can i install the rain diverter on the side of a roof and if i do how do i get the water back into the gutter.

Roof water diverter installation.

Thick bead of clear silicone caulk on the underside of the drip edge lift the shingle tabs up slightly and slide the diverter under the tabs. Our diverter comes fully assembled and ready to install by qualified contractor. Spray paint bottom surface and up turned edge of flashing to match color of roof. Using a pry bar or putty knife loosen the second row of shingles up from the edge of the roof where the diverter will be located.

Order your diverter online and receive within a week. Slide the diverter under the shingles. Installing a rain diverter on your roof is useful if you have a place where water runs and you don t want it to. Cost effective solution that is easy for professionals to install.

To install a rain diverter on your roof. Roof valley rain water diverter is the only product on the market that solves the problem of overflowing water on an a roof. A rain or water diverter will keep a doorway. How to install a rain diverter on a roof 1.

It prevents rain water from cascading on the inside corners of the shingle roof. Climb a sturdy ladder and locate the second row of shingles closest to the roof edge. A drop of 1 is plenty for a 6 diverter. Slide the diverter in.

Roof rain diverter installation steps sand underside of flashing with 80 grit sandpaper to help paint adhere. Slide one end of the diverter tight to the bottom of the shingle tabs and leave a 1 in. Lift the shingles to nail the. I have water running off the side of my roof as evidenced by the mud splashed up on the side of my house and a water channel in my flower bed below.

Diverter is made from 24 gauge aluminum that is rust resistant and flexible to accommodate different roof angles. The edges of product s body are bended inside to prevent water back up under roof shingles. Exposure at the other end to create a drainage pitch. Cut flashing in half using aviation snips.

Start by cutting the flashing with tin snips about 2 3 feet longer than the doorway you want to protect. Loosen up the shingles by. I need to prevent this problem as i do not want a wet basement. Slant the diverter so that one side is slightly lower than the other to allow for drainage.

Use flat pry bar to loosen stuck roof. Slide the diverter under the row of loosened shingles.