Safety mesh does not prevent falls from the edge of a roof or through unmeshed holes in a roof so.
Safety mesh under roofing.
Also used to support underlays where spans fall outside recommended distances.
Roof safety mesh is welded steel mesh attached to roof framing to eliminate the risk of falls during construction as well as acting as a support for the roofing underlays and insulation and any further roof maintenance work.
Galvanised products do corrode and cannot provide adequate protection.
Safety mesh is designed to prevent internal falls through a roof.
If securely fixed safety mesh provides fall protection for roof installers and offers long term protection against falling for maintenance and repair workers.
Therefore safety mesh always needs to be used with appropriate edge protection guardrails or fall arrest systems and devices.
Galvanised safety mesh complying with as nzs 4389 2015 for use in commercial roof applications where falling from high hazards exist.
Safety mesh does not control the risk of falling from the perimeter or through penetration hazards.
Stainless steel roof safety mesh provides fall protection during construction and maintenance for the life of the building.
When to use under roof safety mesh.
It also provides a permanent safe working environment under skylights and clear composition roofing.
Staging on the roof surface to spread the loads safety mesh secured under fragile roofing or skylights.
3 2 fixing connections between the roof safety mesh and the roof member.
Appropriate lifting technique for long roof conforms to as nzs 4389 2015 roof safety mesh is installed by a competent person in a safe manner and in accordance with the manufacturer s instructions.
Roof safety mesh ausmesh sets the standard.
3 4 lapping where the sides of roof safety mesh are overlayed to prevent a gap forming between the two.
Safety mesh consists of 2mm galvanised wire with a tensile strength exceeding 450 mpa.
Provides fall protection for roof installers and offers long term fall protection for maintenance and repair workers.
But ausmesh has been setting the standard for roof safety mesh throughout australia nz and s e asia for thirty years.
The provision of a permanent safe working environment throughout the roof installation and for future maintenance work can be achieved by using the safety mesh system over the entire roof plane.
Complies with the requirements of australian standard as4389 1996 for safety mesh with galvanised coating grade w02z.
If safety mesh is used ensure it.
A ring fastener or hog ring used for joining side laps of roof safety mesh.
The longitudinal wires are spaced at 150mm centres with crosswires spaced at 300mm centres.
Death and injury from roof falls or falling objects is a major concern for anyone who works on or around large scale roofing projects.
