If the wall control doesn t light up and work properly then the wall control or the logic board in the garage door opener is defective.
Sears garage door opener wall control not working.
The lock button feature disables all remotes.
The premium wall control listed for the garage door opener is 41a4884 and that wall control will operate everything.
The safety sensors are located near the bottom rear corners of the garage door track.
If the garage door opener works it means.
Craftsman garage doors and door openers are usually reliable but sometimes things go wrong.
Unplug the garage door opener and check the wiring connections on the panel.
Install the new wall control.
If the green light blinks on the wall control the lockout feature is on.
Remove the wall control.
The wall control part number 53687 will operate the door.
If the garage door opener lights blink twice when you press the remote check the wall control to see if you have the lock feature enabled.
Push down on the control button locking tabs to release them and then pull the control.
The fix is usually something minor.
To know for sure what the problem is you may want to have a service technician check the garage door opener.
Depending on the model most work by connecting two to four wires onto terminals mounting the device on the wall and then plugging the unit into an electrical outlet.
Checking each of the parts of the garage door opener and the garage door itself will usually reveal the problem.
It may be as simple as new batteries or replacing wires.
The only feature that may not work is the lock and light feature.
If they are blocked by paper dirt on the lenses or any type of debris the remote may still send a signal to.
Disconnect the wall control wire.
Won t work if the motor unit has power but won t respond to any remote or the wall control the logic control board could be the problem.
Press and hold the lock button for 2 seconds to disable the feature.
A wall console unit for a garage door opener is not a complicated device so it s fairly simple to troubleshoot when something seems to go wrong.
You will need a screwdriver for this touch the bare ends of the wire together to see if the garage door activates.